Addendum to permit #13-18388-vcgen, including revisions approved 2/11/14 by the ac, and per drawings submitted 01/24/14, and stamped vcc approved 02/18/14, as follows: the two (2) arched, masonry openings at the corner entry at decatur & ursulines, previously approved to contain divided-lite transoms, will be left open and devoid of millwork. The ceiling of the corner entry alcove will be constructed of bead-board

Addendum to permit #13-18388-vcgen, including revisions approved 05/27/14 by the ac, and per drawings submitted 05/20/14 & 06/16/14, respectively, and stamped vcc approved 06/16/14, as follows: the approved design of the ground-floor canopy shall be constructed with a 45-degree chamfered or clipped corner rather than the approved 90-degree corner.

1. To renovate three-story building with commercial space on the ground floor and four residential units on the two upper floors building per vcc approval granted 4/16/13 and final drawings received 5/28/13 and stamped approved 6/7/13. Note: exterior work includes the reconstruction of original masonry features: the two brick pediments and the brick column at the corner entrance, as they previously existed, as well as construction of a rooftop stair penthouse to house a staircase providing access to new deck area for tenants and for servicing hvac equipment. This permit also serves to satisfy the provisions for the change of use, as noted in article 8, section 8. 1 of the new orleans comprehensive zoning ordinance.

To remove graffiti from masonry walls utilizing diedrich 505 special coating stripper per approved specification sheets stamped 04/24/14, manufacturers specifications, and the following specifics: prepare a test panel or test a small, unobtrusive section of the wall in situ. Pre-wet the surface as a precaution against solubilized paint being absorbed via capillary reaction by and staining porous masonry surfaces. The surface should not be allowed to dry at any time during the cleaning. Rinse the treated area thoroughly, removing any residual cleaning products and solubilized paint. If pressure washers are used, pressure should not exceed 5 psi. Always rinse surfaces from top to bottom using a 45 degree fan-tip nozzle. Maintain a minimum distance of 18 inches between the nozzle tip and the masonry surface. Use the lowest possible pressure to achieve desired results. Once test is complete, applicant should contact the vcc for a visual inspection. If the results are satisfactory, vcc staf

Paint doors, windows, trim, canopy brackets, and underside of canopy doors, windows, trim, & underside of canopysherwin williams sw7008 alabaster canopy brackets/ironworksherwin williams sw6991 black magic

Addendum to permit #13-18388-vcgen, including revisions approved 05 27 14 by the ac, and per drawings submitted 05 20 14 & 06 16 14, respectively, and stamped vcc approved 06 16 14, as follows: the approved design of the ground-floor canopy shall be constructed with a 45-degree chamfered or clipped corner rather than the approved 90-degree corner.

Paint doors, windows, trim, canopy brackets, and underside of canopy doors, windows, trim, & underside of canopysherwin williams sw7008 alabaster canopy brackets ironworksherwin williams sw6991 black magic

Addendum to permit #13-18388-vcgen, including revisions approved 2 11 14 by the ac, and per drawings submitted 01 24 14, and stamped vcc approved 02 18 14, as follows: the two (2) arched, masonry openings at the corner entry at decatur & ursulines, previously approved to contain divided-lite transoms, will be left open and devoid of millwork. The ceiling of the corner entry alcove will be constructed of bead-board

To remove graffiti from masonry walls utilizing diedrich 505 special coating stripper per approved specification sheets stamped 04 24 14, manufacturers specifications, and the following specifics: prepare a test panel or test a small, unobtrusive section of the wall in situ. Pre-wet the surface as a precaution against solubilized paint being absorbed via capillary reaction by and staining porous masonry surfaces. The surface should not be allowed to dry at any time during the cleaning. Rinse the treated area thoroughly, removing any residual cleaning products and solubilized paint. If pressure washers are used, pressure should not exceed 5 psi. Always rinse surfaces from top to bottom using a 45 degree fan-tip nozzle. Maintain a minimum distance of 18 inches between the nozzle tip and the masonry surface. Use the lowest possible pressure to achieve desired results. Once test is complete, applicant should contact the vcc for a visual inspection. If the results are satisfactory, vcc staf

1. To renovate three-story building with commercial space on the ground floor and four residential units on the two upper floors building per vcc approval granted 4 16 13 and final drawings received 5 28 13 and stamped approved 6 7 13. Note: exterior work includes the reconstruction of original masonry features: the two brick pediments and the brick column at the corner entrance, as they previously existed, as well as construction of a rooftop stair penthouse to house a staircase providing access to new deck area for tenants and for servicing hvac equipment. This permit also serves to satisfy the provisions for the change of use, as noted in article 8, section 8. 1 of the new orleans comprehensive zoning ordinance.